I've been working on my New Haven Coastal Route since Jan 2012 it is a conversion of msgsapper's New England Coastal. You all have probably seen screenies over the years. In the last year or so I've mainly been using it for beauty shots or fooling with merging, testing new assets, and etc. Yesterday I thought I'd run some passenger sessions to explore how this was working in TANE SP3, to my surprise in manual mode I was unable to load passengers. E.G. I drove to a station and the passenger didn't load/unload. I tried various trains and various stations on the route and none would work. The stations all showed up as possible destinations in the Navigate To menu but, if I set it up the train it would not move and there was no error messages. I verified that telling the train to go to various portals and industries worked. Some of the destinations were past the stations that were not working without problems so it appears that it is not a problem with the track, in other words no disconnected tracks.
I keep my earlier versions of my route and have 12 versions in TANE and 5 versions in TS12. I began backtracking to see when the problem began. I verified that the problem was present in build 90945 and 88364 on my current version of the route so I started working my way back through the versions. Apparently the problem began when I converted the route to ProTracks in May of 2017. During this testing I found that while it appears all stations are affected only some of the industries were affected.
Does anyone have any suggestions as to how to salvage my current version of the route? I've done a lot of work over the last year and would hate to loose it all. My only idea at this point is to delete each problem asset and then replace it and I'm not 100% sure that will work.
I keep my earlier versions of my route and have 12 versions in TANE and 5 versions in TS12. I began backtracking to see when the problem began. I verified that the problem was present in build 90945 and 88364 on my current version of the route so I started working my way back through the versions. Apparently the problem began when I converted the route to ProTracks in May of 2017. During this testing I found that while it appears all stations are affected only some of the industries were affected.
Does anyone have any suggestions as to how to salvage my current version of the route? I've done a lot of work over the last year and would hate to loose it all. My only idea at this point is to delete each problem asset and then replace it and I'm not 100% sure that will work.