Franklin Avenue Industrial

After runnin the FAI, Train Assembler Session I am having trouble with engines not responding to throttle changes. No matter how much power I give the engine, it won't move in either direction.

Anyone else having this issue, or have any ideas why this is?

Thanks

Sounds like you parked it on one of the tight curves. I done that and had to start all over on the session, which made me not play the route anymore.

With the "big engines", its best to stop the AI, change the switch so the signal is not red, and push the train onto the mainline so you can make the tight curve without stopping.

As above same issue curves are tight need to park on straights a fair distance away from a curve.

Thanks for the tip guys, will give it a try. If that's the problem, there should be a fix for it.