Vanishing track

I have managed to rotate a section of track from the horizontal (east - west) to the Vertical (north - south), I have saved as under another name, when I checked out that section it clearly showed that the track ran north south however when I tried installing into the route, 95% of the track in that section had vanished and it was still pointing east west...My Ts-12 is build 58414.

Is there a method of updating updating Trainz build numbers enmasse, I have recently reinstalled TS-2 and a lot of previously corrected errors have shown up

Thanks

OH what the heck..I don't have a clue what your posting about.
What did you save under another name? What are you trying to do?

Sorry I don't have TS2 so I can't help.

I think he means by 'east - west' and 'north - south' is the compass in Surveyor. The 'rotate a section of track' must means it is a track found in the Buildings/Objects in Surveyor, which are 'Fixed Track', normally switches, that he's rotating.
@DESDICHATO:
The errors could have to do with your problem. Can you provide what the errors are?

Well yea....I know you can rotate fix track TO ANY POINT of the compass but it shouldn't disappear.
Were only guessing until some clarification.

Is it going on the wrong layer or in the session rather than the route?

John