Cab Signals

R

robertkl

What you doin in me swamp

• Dec 1, 2014

• #1

I have bought the CSX SD70MAC Pack a while back. and when downloading the cabs for the i notice 2 of them have cab signals. how would I get them to turn on in driver/ and where would the be located in the cab?? i run The RF&P Sub, Which uses Cab Signals

I Run TS2010

 

norfolksouthern37

what's a normal map?

• Dec 1, 2014

• #2

They are in the very center of the cab at the front between the windshield. Simply place one of the equipped locomotives in the lead and enter the cab, the signals will be there.

 

R

robertkl

What you doin in me swamp

• Dec 2, 2014

• #3

is there a picture you can post? IDK I maybe looking in the wrong spot. or I might be doing something wrong. EMD WideCab Type 5 is what I put In there

 

norfolksouthern37

what's a normal map?

• Dec 2, 2014

• #4

this is a UP one but the cab signals in the same place.

 

R

robertkl

What you doin in me swamp

• Dec 2, 2014

• #5

do i have to do anything in explorer?

 

norfolksouthern37

what's a normal map?

• Dec 2, 2014

• #6

no just use the locomotive. The flared radiator ones are the ones with the cab signals iirc.

 

B

bunkerrattmk2

CNW the left hand road.

• Dec 2, 2014

• #7

you need to install the correct cab for your version of trainz. then you may have to commit it in cm?

 

R

robertkl

What you doin in me swamp

• Dec 2, 2014

• #8

no success. but hey thanks for tryin to help..