Repeating Rules in Session

paulper

Member
Hi all,

In my attempt to perfect the triggering of platform announcements on my Dartford to London route, for through stations in Edit Session Rules, I use Trigger Check then Switch Junctions as a child rule to trigger the platform announcement from a lever I cloned on an invisible track next to where I want the announcement to take place on the map. This works fine and will repeat endlessly.

For terminals I use the same, but Wait as a middle rule to delay the announcement until a few minutes before the train is due to depart. The announcement occurs once but then will never happen again during the session.

I have swapped the Wait rule, Trigger Check and Switch Junctions for something similar but seemingly because of the 'Wait' it doesn't seem to want to repeat the Trigger Check and Switch Junction commands.

Any ideas as to how to delay a rule but ensure it runs repeatedly?

Many thanks in advance.

Paul
 
Last edited:
Back
Top