Route Transfer From TS10 To TS12

steve123

Active member
I have transferd a rout from Trainz 2010 to TS12 including a clean install of TS12, now everytime i installed a new patch for TS12 i ran the route to make sure it was ok, and also each time i did this i changed a command in Driver Setup, first patch i installed was 46957 to 48249 all ok then i installed patch 48249 to 49922 all ok then i installed 49922 to 57720 now when i went to test the route out for this patch every time i would change a command in Driver Setup the session loading would go to an error, however if i didn't change the commands in Driver Setup it would load correctly.
Makes it hard if i can't load any other Loco or command, in the error box it gives no notification of what the error is, Anyone know of a fix for this.

thanks
 
Back
Top