shinoda2005
New member
So in the route I'm building I had an engine back down onto cars that are in a siding. It would then pull forward until it was past the points then back up to be switched on the main line to get to its destination. To make it easier, I decided to add to the siding so that instead of the siding ending at the bumpers, it runs to the main line. This issue with this is is that now when it hooks up to the train it doesn't move in either direction because 'the block is occupied, the train might need manual help to turn around'. The thing is the block isn't occupied, the signals are green, all the switches are in the right position as well. I've tried adding and removing signals and it doesn't seem to help. Does any one here any ideas what I can do other than going back to just the standard siding? If more info is needed I can post screen shots, thanks.