davoss

I am creating in Trainz the Everett & Monte Cristo Ry, that existed from 1893 to 1905, both as a layout that contained only 1.5 miles of...

The Tangent distance is the minimum distance between any two tangent tracks whether inside or outside the yard. Several days ago, I...

Fortunately, these RPs also include prototype dimensions. That is what I am using. You are right, in Trainz we use quite broad curves...

Below are the three Track c-c gauges for Old Time before 1920, Classic for 1920 to 1969 and Modern for after 1969. I will be uploading...

Here are the three Track c-c gauges for: Old Time before 1929, Classic 1920-1969 and Modern after 1969. The basis for these c-c...

Here is a screenshot of Clearance Gauges for Old Time and Modern as well as Track c-c gauge for Old Time and Modern I managed to get...

There is not a lot of room on my tool to also show c-c distance. NMRA RP-7.2 does show this distance - although in feet not meters. I...

Hooray! I did it.

I successfully uploaded my screenshot to the Trainz Portal; copied the url and tried to post it here. I clicked on the "Insert image"...

Once again, I made a mistake in the last table. Change Prototype Radius 15 degrees from 175.0 to 116.7. Changed. I have designed a tool...

There is a mistake in the table above. Classic(ft.), 45 degrees Curvature shows 13.0 ft. This should be 23.0 ft. I have converted feet...

Please realize the Clearance Gauge tools I have uploaded to the DL station contain a track c-c for tangent yard tracks only. In order to...

I like it.:)

Thanks. I will review.

I just uploaded to the DL station 4 clearance gauges: Before 1920, Classic, Early Modern and Modern. They all start with "Clearance...