Merddyn4147
New member
Further to last post early this morning to the blog area, a few more comments.
1. I saved game early this morning and can't find where it saved.
2. The "rough handling" and "excessive accereration" come up at 2 KPH when shunting. Tolerance must be set too fine.
3. Passenger ick ups Foggerty's End doesn't occur till 0.3km past the 0.o km point and at Arsao ame thing, but at 0.1km past the 0.0km point.
4. A suggestion is the "^" showing train position on the gradient / route graph might be better larger and actually across the route rather than pointing to the point on the line. Might be a bit difficult. Suggest you see Water Street Productions Historic Queensland Cab Rides Volume 1 for another way this can be done. ie. the route passed over changes colour.
5. Won't do a bug report for this but at the terminus, no written instructions appear to tell you to uncouple loco: just says turn loco. True, sensible people would realise must uncouple, but as Monty Python said in that BBC / Queen sketch - People are stupid and will do silly things.
6. Turning loco easy but ends of track on turntable vibrate when turning - obviously lag as position of table changes.
7. About to do return from the terminus after turning loco with all settings changed from the "oob" to ultra / maximum.
So far my GTX1081Ti with 11gb memory handling it well although a couple of times screen momentarily froze [1/10sec or less] and "rough handling" came up.
8. Two main bugs which will report on ASAP. Several error messages and the writing that appeasrs above the route gradient only shows about bottom third and can't therefore be read.
Cheers
Garry
1. I saved game early this morning and can't find where it saved.
2. The "rough handling" and "excessive accereration" come up at 2 KPH when shunting. Tolerance must be set too fine.
3. Passenger ick ups Foggerty's End doesn't occur till 0.3km past the 0.o km point and at Arsao ame thing, but at 0.1km past the 0.0km point.
4. A suggestion is the "^" showing train position on the gradient / route graph might be better larger and actually across the route rather than pointing to the point on the line. Might be a bit difficult. Suggest you see Water Street Productions Historic Queensland Cab Rides Volume 1 for another way this can be done. ie. the route passed over changes colour.
5. Won't do a bug report for this but at the terminus, no written instructions appear to tell you to uncouple loco: just says turn loco. True, sensible people would realise must uncouple, but as Monty Python said in that BBC / Queen sketch - People are stupid and will do silly things.
6. Turning loco easy but ends of track on turntable vibrate when turning - obviously lag as position of table changes.
7. About to do return from the terminus after turning loco with all settings changed from the "oob" to ultra / maximum.
So far my GTX1081Ti with 11gb memory handling it well although a couple of times screen momentarily froze [1/10sec or less] and "rough handling" came up.
8. Two main bugs which will report on ASAP. Several error messages and the writing that appeasrs above the route gradient only shows about bottom third and can't therefore be read.
Cheers
Garry
