View Full Version : Change in elevation for "Riverwater texture"

August 2nd, 2008, 06:35 PM
Would like to know if there is a method to change the "River Texture" elevation when the river is following a terrain that is inclined. When installing "River texture" I have to step down sections by about 1 to 3 feet in order to have the river follow incline of the terrain.
Any suggestions on this subject!
Thank you and have a good day.

August 3rd, 2008, 03:30 AM
Use a River spline is possibly the best solution there are several available from the DLS
Regards Bob V

August 3rd, 2008, 08:11 PM
There are river splines?:eek:
Wow, gotta add a note to a Notepad document.