PDA

View Full Version : Junction Signals



Nimrod228
July 23rd, 2008, 05:28 AM
Why is it that if I use a semaphore with a left branch it always signals straight ahead regardless of the switch setting ? I've tried various combination of signals and track layouts but the junction signal always remains the same. Any help would be appreciated.

trackplate
July 23rd, 2008, 06:13 AM
Chances are you are missing a signal ahead of the branch signal as in the signal ahead is missing
Hover the curser over the signal and it will tell you so, to clear the problem with crossovers use invisible signals
Also check and be sure that you have the junction leave slightly outside the spline point on the approach side
Also place a rolling stock item on the track in surveyor to check the operation
If you have downloaded any of my routes take a look round in surveyor for examples
Regards Bob V