Wireframe Invisible

[Faithworks]

I'm running TS09, and right up to date build-wise.
In surveyor when I start out the baseboard's wireframe is fully visible as you'd expect, but as the layout gets bigger (and/or) I add objects the baseboard changes from wireframe to a yellow colour - sometimes back again - it seems to happen for no reason.
In one of my layouts the baseboard is always yellow, the wireframe is not visible, when I select wireframe using the wireframe button the baseboard changes to a bright white-blue colour, still no view of the wireframe.
So modelling the terrain detail - eg around tunnel portals or at the crest of cuttings - becomes virtually impossible because I can't see the nodes to move them up and down. Adding texture makes no difference.
Must be a common problem? Anyone know the answer, please?!
Thanks in anticipation

 

[hert]

I am a little confused on what your asking? Wireframe mode is selected on the top bar and makes topology have white gridlines and you can see through the ground and cant see any textures. When you start a map the default texture is gray with yellow gridlines and has nothing to do with the wireframe option.

hope this helps a little,

hert:wave:

 

[danny5]

I have the same problem but mine in TRS2010. My boards some times don't show up after i put down some track,just the track shows up no board no yellow wire grid. Some times nothing at all just a blue screen. The boards are at one end of my route that don't show up all the rest look fine just the two boards. Trains will run on these boards but will not show until they reach the third board.

 

[Faithworks]

The problem isn't to do with the initial baseboard - yellow gridlines on grey texture - that's fine – and sometimes that’s what I see (below).

But, what happens when I move around is that the grey texture automatically becomes this washed out yellow colour and you can't see the gridlines any longer (below).

Furthermore, when I click on the wireframe button, instead of the wireframe becoming evident, the texture of the board switches to a bright whitish blue - again no wireframe (or gridlines) evident (below)!

May be it’s not a common problem after all.
Ideas welcome.

 

[ShadyCadence]

What's the thread exception about?

 

[Faithworks]

Sorry - what thread exception?

 

[clam1952]

Sorry - what thread exception?

Red circle on the bottom right of the screen, signifies a thread exception, probably the cause of the problem and more than likely related to an asset. Click on it and a box will open giving details, should be a further info more details or similar button for more information, if I remember correctly.