Turning junctions automatically

[okhiu]

Hello,

I have a question regarding the junctions.

Suppose we have the junction J with 2 sidings, A and B. One train passes over junction J and goes on siding A. I want junction J to turn automatically after the train passes (probably when it hits a trigger) so that the train that i drive can go on siding B without me changing the junction J manually. How is this possible? I have seen this in the built-in sessions of Iberia Interior. Can someone help me because i didnt managed to discover how was that made.

Thank you. :wave:

 

[TomDean]

Hi Okhiu

Try this - it should work.

In Surveyor, set junction J to siding B. Then in Driver, if the first train is under Driver control it will set J to siding A to allow it to enter and then reset to the default position, B, to allow you to drive your own train in without having to change J.

I hope it does work.

Cheers

TD

 

[okhiu]

Hi Okhiu

Try this - it should work.

In Surveyor, set junction J to siding B. Then in Driver, if the first train is under Driver control it will set J to siding A to allow it to enter and then reset to the default position, B, to allow you to drive your own train in without having to change J.

I hope it does work.

Cheers

TD

Hello thanks for the advice, i will try this. Anyway, i dont know if that session of Iberia Interior is made like this....