TRS2009 Object Height Problem

[beechyhead]

I have had a couple of problems with getting TRS2009 to run (I am using Parallels on a Mac) but finally managed to get it to go with the DirectX settings. It seems to work ok, until I started to make a route today, and when I wanted to adjust the height of a building or bit of trackit just goes straight down to -50. Occasionally I did get it to go back up but then it went to +50! That's not a whole lot of use!

Just wondering if anyone else has had a similar problem?

 

[DonZer63]

Hi,

use the "Strg" or the "Shift" Key while change the high. This allowed smaller steps.

Greetings
Don

(Excuse my english please, hope it´s understandable!?)

 

[beechyhead]

Seems to be ok

Thanks for the advice, but it seems to have cured itself! The next time I went into the game, it is working ok! I'm glad I can finally play Trainz on my Mac!

 

[beechyhead]

...Or not!

Have been playing the last couple of days and for some reason it is doing it again. Does anyone have any other suggestions!?