trouble with YARN road splines separating at fixed juction connections?

[MicroLynkx]

I have
TS12 and really enjoy it, but recently have been having problems with my road splines disconnecting from intersections and fixed point junctions. I was wondering if there was anyone out there with some tips for me?

Thankx

Billy

Rio Grande & Pacific - Colorado Division.

 

[Stewartbf6]

I found that the updated YARNish updates seem to help with this problem, they on DLS

 

[socalwb909]

-I've been wondering about this too. Hopefully someone can shine some light on this.

-Joe

 

[Dermmy]

@ OP - with TS12 you should really be using the updated 'Yarnish' clones, not the originals. Also this thread might be worth a look http://forums.auran.com/trainz/show...ish-highways-Treadway-streets-bug-reports-etc

 

[MicroLynkx]

I am going to add a problem. I really appreciate the comments. I have tried to use the Yarnish closes and they seem to work a little better. but now I am having a problem with the roads joining one or more of the fixed intersections are buckling. the roads are lifting right off terrain and creating the most unusual and interesting arches. Does anyone have any suggestions, other than placing multiple spline points on all my roads?

 

[JCitron]

I am going to add a problem. I really appreciate the comments. I have tried to use the Yarnish closes and they seem to work a little better. but now I am having a problem with the roads joining one or more of the fixed intersections are buckling. the roads are lifting right off terrain and creating the most unusual and interesting arches. Does anyone have any suggestions, other than placing multiple spline points on all my roads?

Try replacing the roads with either YARN or YARNish ones. The problem is the offset for the attachment points are different on these intersections compared to others, causing the roads to arch downwards into the ground.