Train Mode in Driver Causing a Problem
- Thread starter jkinzel
- Start date
shaneturner12
Tutorial Creator
I'm a bit confused - would you be able to supply a screenshot of that feature?
Shane
Shane
Thank you Shane. Edit: I should mention, this is TANE, SP1, Build 81296
The photo was taken in Driver and for some reason the information windows were removed in Print Screen. In the upper left corner is a Portal track with the engine of a returning train stopped. On the right side, about mid photo is where the "Train Mode"or F7 tab is located. No other tabs are displayed.
When I click on the "?" in the very upper right hand corner, three options come up, one of them being "Get Help On". I choose that and then click on the"Train Mode" tab and it brings up a page "Help: Surveyor Train Tools" and "Train Mode". Lots of good information, but nothing to tell how to turn "TrainMode" on or off. It seems that with the "Train Mode" on, trains returning from a portal stop after the first vehicle displays and will not continue regardless of the amount of time allowed.
Thank you for any help.
Regards,
The photo was taken in Driver and for some reason the information windows were removed in Print Screen. In the upper left corner is a Portal track with the engine of a returning train stopped. On the right side, about mid photo is where the "Train Mode"or F7 tab is located. No other tabs are displayed.
When I click on the "?" in the very upper right hand corner, three options come up, one of them being "Get Help On". I choose that and then click on the"Train Mode" tab and it brings up a page "Help: Surveyor Train Tools" and "Train Mode". Lots of good information, but nothing to tell how to turn "TrainMode" on or off. It seems that with the "Train Mode" on, trains returning from a portal stop after the first vehicle displays and will not continue regardless of the amount of time allowed.
Thank you for any help.
Regards,
Last edited:
shaneturner12
Tutorial Creator
It's unlikely that that train tab/mode is the cause of that issue as it's been in a few builds. Might be worth checking if there are any red icons at the bottom.
Shane
Shane
Sorry I took so long to get back, reality keeps bothering me.
I'm at a loss, I have no bugs and I have added a board and placed the portal on solid ground, so to speak and I have also tried several portals all with identical results. I have run trains in other routes with portals and and bugs and they work just fine so it does not appear to be a blanket problem.
While bothersome, I'm not going to lose much as this was just a one board narrow gage route with not a lot of time invested.
Thank you everyone for your assistance.
Regards,
I'm at a loss, I have no bugs and I have added a board and placed the portal on solid ground, so to speak and I have also tried several portals all with identical results. I have run trains in other routes with portals and and bugs and they work just fine so it does not appear to be a blanket problem.
While bothersome, I'm not going to lose much as this was just a one board narrow gage route with not a lot of time invested.
Thank you everyone for your assistance.
Regards,