Whenever I have to build one of these bridges, I use a combination of Maddy25's 'Plate Girder Bridge, Bendy', and 'Warren Through-Truss Bridge, Steel'. The two different bridges match perfectly, and allows for bridges that has curves on them. However, the bridge piers that go with them won't work when you combine the two bridges. To rectify this problem, I use Natvander's 'Bridge Pylon Girder Lg' for where the 'Plate Girder bridge, Bendy' meets the 'Warren Through-Truss Bridge, Steel'. Also, if I add some extra piers on these bridges, I use the 'Bridge Pylon Girder Lg' for multiple 'Warren Through-Truss Bridge, Steel', and Natvander's 'Bridge Pylon Girder Sm' for the 'Plate Girder Bridge, Bendy'. However, if I'm using just one of these bridges, I use the bridge supports Maddy25 made for them. As for bridge ends, if the bridge is level, I use either Maddy25's 'Abutment - concrete' or wawasoo's 'YR Abutment - Wood LEVEL'. If it's on a grade, I use wawasoo's 'YR Abutment - Wood UP' for the 'higher end' of the bridge, and 'YR Abutment - Wood Down', for the 'lower end'.
