timetabled shedule

[jalleballe]

can i make a timed shedule. forexample start at A1000pm to B1020pm and so on.
and can i make this for the AI driver? or is it just commands like wait for that can be used for that?

 

[Kennilworth]

Hi

There are 2 commands on the DLS which are "Wait for Hour" and "Wait for Minute" and these can be used to control the start time for each consist.

I also believe that there is a portal that can be set to produce consists at set times but I haven't used it myself. Perhaps someone else can comment on that.

I use the SCS2006 rule for producing scenarios and have successfully programmed almost 50 trains to run to a 3 hour timetable for the Carlisle area on the SnC route. Using this rule trains can be controlled to the second which can be important when setting paths which don't cause conflicts between trains.

Regards

Brian

 

[itareus]

WaitUntil (Hour/Minute), a driver command <kuid:41009:900005> is a built in driver command for TS2010.

Portal timetable rule, a "session" rule <kuid2:61392:2002:1> is on the DLS. As the name implies it is for trains from portals.

Also check out:

Quick Portal Manager v2, a "session" rule <kuid2:61392:5011:7> - again also for portals.

The above are all for AI operation.