Routes 1 will not load

nightlifejnr

New member
I have just received Trainz Routes 1 & 2 disks. Routes 2 disk loaded fine & went straight into Autoplay, & the installation was sucessful. Routes 1 disk gives the message :

E:\ is not a valid Win32 application

The same happens on my DVD drive D:. The message also appears if I double click on the disk via My Computer & then try running the routes.exe program. I have anitvirus disabled as per the instructions & Disk 2 did load straight away. Do I maybe have a faulty disk 1? Any ideas anyone?
 
I have just received Trainz Routes 1 & 2 disks. Routes 2 disk loaded fine & went straight into Autoplay, & the installation was sucessful. Routes 1 disk gives the message :

E:\ is not a valid Win32 application

The same happens on my DVD drive D:. The message also appears if I double click on the disk via My Computer & then try running the routes.exe program. I have anitvirus disabled as per the instructions & Disk 2 did load straight away. Do I maybe have a faulty disk 1? Any ideas anyone?

Possibly a faulty disk... Did you disable all antivirus-type software before trying to install?
 
Thanks for replying, I think the disk is damaged but thought I'd put it on the forum in case anyone else had the same problem.
The disks seem to have had a rough journey from Australia to the UK as most of the plastic disk holders in the case had were broken off, perhaps these sharpbits of plastic rattling around damaged the disk surface.
I will contact Auran!

Shaun
 
Back
Top