Route doesn't work

[alfredo_20]

Hello!
I have a route in TRS222+ (136192) that isn't working.
Every time I try to start a session, it stops.

In fact, I left the session for five minutes and the hour had not changed. It is like the game is in pause. In the picture you can see the dial speed active but the train doesn't move, same with cars or traffic.

 

[fourteen]

What route, and kuid number

 

[alfredo_20]

It's a custom route I'm working on (it's actually been in development for a few years).
The problem is that this week, for some reason, it stopped working.
Objects load fine and engineering mode works perfectly, but driver mode just won't start.
Interestingly, if I create a new route and append this one, everything works.

 

[colorado71]

Try to save as it under another name.

 

[alfredo_20]

I tried but Ir didn't work.
Also there is no sound and when I try to move some control I have this message: Controls locked

I also discovered that the pause option is always selected. I tried pressing P, but it didn't work. When I pressed P, the message 'Pause' appeared, but when I pressed it again, the message disappeared, although the option was still checked.

 

[martinvk]

Only this session or do other sessions also have this issue?

 

[alfredo_20]

This happens even if I create a new session from scratch. Apparently, the session is paused and there's no way to resume it.

 

[martinvk]

Can you un-pause it while still in Surveyor? Animations in the route should start as well as any consists that were already moving.
Do existing sessions in other existing routes have the same issue? New sessions in existing routes?
How about a session in a new route?

 

[alfredo_20]

No, it was impossible. I tried to deselect the option, but it was still checked (like the above picture).
This is the first time I have seen this error. Fortunately, the other routes work fine.
I also found a backup of the route with a different KUID and name that I created two months ago. However, I'm worried because I don't know what happened.

 

[alfredo_20]

And thank you so much for the help

 

[JCitron]

No, it was impossible. I tried to deselect the option, but it was still checked (like the above picture).
This is the first time I have seen this error. Fortunately, the other routes work fine.
I also found a backup of the route with a different KUID and name that I created two months ago. However, I'm worried because I don't know what happened.

This usually occurs when a script has a fault or something has become corrupted. Did you place any new driver commands or try one of the many rules in your session? The backup copy works because it doesn't have those in the session.

Backups are your friends.