Road Traffic

Where does one go to change the cars that are generated on the roadways? Is it through the config. file for the asset in CM? I want to add/delete some of the vehicles used in TS12. Perhaps slow them down a little, also.

Thanks.
 
Where does one go to change the cars that are generated on the roadways? Is it through the config. file for the asset in CM? I want to add/delete some of the vehicles used in TS12. Perhaps slow them down a little, also.

Thanks.

Yes, just switch out the kuids in the Config file (of the REGION you are using) for the ones you want. Don't forget to also change the same ones in the "Kuid Index."
 
Yes, just switch out the kuids in the Config file (of the REGION you are using) for the ones you want. Don't forget to also change the same ones in the "Kuid Index."
Would that be the "kuid-table" at the bottom of the config. file ? On the road I pulled up ( YARN L2 DL1 + 0Si-2Si+Sh ) it reads:

kuid-table
{
}

Would I enter the car kuids that I want within the brackets ?

Thanks.
 
Would that be the "kuid-table" at the bottom of the config. file ? On the road I pulled up ( YARN L2 DL1 + 0Si-2Si+Sh ) it reads:

kuid-table
{
}

Would I enter the car kuids that I want within the brackets ?

Thanks.

No, the road has nothing to do with it.

It's the REGION file and the REGION kuid index.

Look for the region kuid in the route config:




Open the Region Config and you'll see a list of cars that are used:







Simply add, change, or delete the cars you desire.


Hope this helps.

Cheers,

Dave Snow
 
Last edited:
Back
Top