Problem with the 'Load' Command

Ian_Coleman

New member
In Driver, when using TRS2004, and running AI trains, I sometimes get a message "Issue 'Drive To' command prior to 'Load' command, and the AI train freezes.

Invariably, in this situation, the command prior to the 'Load' command was a 'Drive To' or more often a 'Drive To Trackmark' command.

Can anyone tell me why this happens in some situations, and not in others, and more importantly, when setting up the commands in Surveyor, how can I prevent this situation occurring?

Ian
 
Hi Ian,

If you are using passenger enabled stations and using a drive to trackmark then wait xx seconds command to get them to stop in the right place, do not use a load command. When the train stops at a passenger enabled station it will load passengers without the load command. However if you use the drive to-station xx then you do need the load command.

Cheers,
Bill69
 
Last edited:
Back
Top