Problem with Biriburra Yards Scenario

cmoseng

New member
Hi All,

I don't believe this to be a bug as I have searched the forums and there appears to be no references to my problem.

I am very new to Trainz. I have been able to complete most scenarios in 2004 but I cannot complete Biriburra Yards. I complete the shunt but when I go to the depot signal protecting the crossover into the Depot is always red.

Further, if I pass that signal and continue with the scenario, when I couple to the pick up consist, the scenario ends with a "Train collision detected message".

What am I doing wrong?
 
Thanks for your reply Whitepass.

I found the document to which you referred and I followed the walk through
exactly but the end result was still the same.:confused:
 
Which version of TRS2004 do you have? The latest one is version 2.4 Build 2365. You can find the build in the lower right hand corner after you launch Trainz.
I think that one of the service packs for TRS2004 caused the 'train collision detected' that you're seeing. A later service pack fixed the problem. The latest one is SP4.
 
Hi Jimi,

Thanks for your reply. My version looks like it is pre SP2 and I have ordered 2006 so I will wait and install that.
 
Back
Top