Point Lever

[uh1h]

After saving a layout I built and then going back in to drive, all of the point switch indicaters (the Red and Green arrows) are all Red and are inoperable, but when I go back into Surveyor they operate normally.
Any feedback would be apprreciated.
Thanx.

 

[BobCass]

Hi uh1h: It looks like too me that when you switch to Driver, for some reason the switches are not aligned correctly..You might try to go into surveyor and adjust all your switches..When its red (both)that indicates that they are out of alignment..You can adjust these by clicking(LMB)left mouse button, on the track tab..Then click(LMB) on the center button(TOP)..This puts it in the correct mode, then click(LMB)on the move button..Click on arrows(LMB)and hold..it should move arrows, either push away from you or pull towards you..when its the correct position they should be red and green..

 

[uh1h]

RE: Point Level

Hi Bob thank you for your quick reply.
I have tried your fix and all points work if I drive while I am in Surveyor but not in saved sessions.

 

[cascaderailroad]

Your levers must be centered in the spline point circle.

 

[Safio]

Ola a todos eu tambem tenho o mesmo problema switch lever setas vermelhas e verdes quando salvo o jogo ou seja save session quando vou jogar a seguir ficam as2 vermelhas alguem por ai tem a soluçao

Obrigado