Paulztrainz poles

[zuluking]

The new poles do not show up.
Change build from 2.7 to 2.4 and they work.
This is strange as up to build 2.8 I have had no problems before.

 

[Lacker]

Many thanks for the tip.
I had the same problem with alien3's Victor and Valiant. Changing the build number from 2.7 to 2.4 worked for these too.
Only snag, the Valiant is the Victor again, so I will have to investigate further.
Regards Bruce

 

[barn700]

I have found a solution (maybe) am uploading fully TS2009/10 assets now, will be released later today.

The older poles had to have 2.7 on them to be able to upload to the DLS after September. I had added a couple of lines in each to make the poles appear upright over a hill, that caused the problem.

 

[amigacooke]

I get the new poles, but no wires between them.

 

[barn700]

Thats a weirdo of the DLS !!!

I had to increase trainz-build to get them accepted by the DLS, reduce this to 2.4 and the wires are OK