I have a streetcar with trolley poles on the front and rear. Only one pole is raised depending on the direction of travel (the trailing pole). The builtin AI control of pantographs does not operate my poles correctly. To overcome this problem I have been using a script to operate the poles when using AI control. This has worked fine; however, the setup to use the script eliminates the ability to have manual control.
I am seeking a solution that will allow me to have proper AI control as well as manual control. I have tried the Driver Command "PantographState" but the builtin AI overrides the Driver Command.
Does anyone else have this problem? Has anyone found a solution to overriding the builtin AI control of pantographs?
Earl
PS: I run TRS2004
I am seeking a solution that will allow me to have proper AI control as well as manual control. I have tried the Driver Command "PantographState" but the builtin AI overrides the Driver Command.
Does anyone else have this problem? Has anyone found a solution to overriding the builtin AI control of pantographs?
Earl
PS: I run TRS2004