Trainz
I am building a Narrow gauge layout that will incorporate a long bridge system.
The bridge consist`s of a plate girder spanning 110 ft.. There will be about 43 spans required. Each span will be supported by a steel box type structure which is larger at the bottom then the top.
Each structure will vary in height from 37 ft to 45 ft.
The structure should be 10 to 12 ft. square at the top and 20 to 25 ft. square at the bottom setting on a 2 ft. square concrete base at each leg of the structure.
This might be thought of as a long viaduct if you will.
I am not into Blender yet. To do this project would take considerable time to develop and go through the learning curve.
I would appreciate any help on this project. Is there such a item on the DLS. I have looked into the DLS and do not see any item such as noted above.
Thank you and have a good day.
Richard
The bridge consist`s of a plate girder spanning 110 ft.. There will be about 43 spans required. Each span will be supported by a steel box type structure which is larger at the bottom then the top.
Each structure will vary in height from 37 ft to 45 ft.
The structure should be 10 to 12 ft. square at the top and 20 to 25 ft. square at the bottom setting on a 2 ft. square concrete base at each leg of the structure.
This might be thought of as a long viaduct if you will.
I am not into Blender yet. To do this project would take considerable time to develop and go through the learning curve.
I would appreciate any help on this project. Is there such a item on the DLS. I have looked into the DLS and do not see any item such as noted above.
Thank you and have a good day.
Richard