New & Improved Russell Subdivision

[Kris94]

May not be much but just a little sample. It's frustrating that I can't even find the simplest of things. A texture WITHOUT the checkerboard effect!!

 

[rbar_164]

I'm sure this has been brought to your attention before, but while laying down textures hold the {[ or ]} buttons to prevent the checkerboard effect. Also Vary textures rather than making the entire baseboard one colour...

Stevo

 

[Euphod]

I'm sure this has been brought to your attention before, but while laying down textures hold the {[ or ]} buttons to prevent the checkerboard effect.

The problem, as I understand it from his other thread, is that apparently there are some textures that WILL NOT rotate while holding down the keys. I wasn't aware of this either, but others have confirmed it to be true.

 

[Kris94]

Actually yes I have used those keys.

 

[rbar_164]

If you rotate the camera while holding those keys it will stop rotating the texture, so you have to keep the camera still. You can still move around though, just not change angle...

Stevo

 

[Kris94]

If you rotate the camera while holding those keys it will stop rotating the texture, so you have to keep the camera still. You can still move around though, just not change angle...

Stevo

Okay then I'll do that.

 

[Kris94]

How should I do the ballast for the yards?

 

[hert]

Lay down the grass/dirt textures first. Then paint the ballast under the tracks like usual.

hert:wave:

 

[Kris94]

What I mean is how far should I extend the ballast?

 

[Euphod]

There is usually a strip of bare dirt between the ballast, but don't be alarmed if some of the ballast meets at points.

 

[Kris94]

Okay the route is now complete. Will be uploading some screenshots in the freeware announcements section. So hop on over there.