Navigate to

[goomermatt]

HI all
It might be me
But before the update today I was abble to right click control
in cab mode driver and go navigate to track mark
And it would switch to AI and drive there
Now you still get driver commands click on navigate to and nothing happens

hope this makes sence

Matt

 

[1611mac]

Are you using the new SP1 TRS19?
I think this happens in SP1 if you place a Loco, come back from Surveyor to Driver, and give a command while in Pause. If you un-pause I believe you will have downward pointed chevrons. Click those and enter your navigate to command. If not, go to roaming (4) move a bit, "2" to focus loco, and try again. Be looking for the chevrons.

The key is to UN-PAUSE when returning from Surveyor before you do anything else.

 

[goomermatt]

thanks that works