Navigate to Trackmark problem

[Approach_Medium]

Hi;
I give the train a Navigate to Trackmark command in driver to go to a trackmark that is in front of the train (some 80 miles away).
The train will not start moving because the following message appears in the message center:

Unable to plot route. Junction is missing lever.

Does this mean that any junction on the entire route is missing a lever, or a junction that is between the train and the trackmark?

I have checked quickly over the distance between the train and the trackmark and I didn't notice any junctions that are missing levers, but there could be lots of them on a different part of the route, which would not be involved in the routing of this train.

Thanks

FW

 

[mcguirel]

Does this mean that any junction on the entire route is missing a lever, or a junction that is between the train and the trackmark? = junction that is between the train and the trackmark

 

[fran1]

Trian-trackmark unfortunately, to try to narrow it down a bit add some drive via t/ms if you have any then you've less track to check.

 

[Approach_Medium]

OK. I'll add some other TM's and see what's up.

Thanks

FW