Junctions and the LOCK!
- Thread starter GeorgeCW
- Start date
Hi George,
You sure can change the 20m limit, but as you said you can't remove the padlock.. In Surveyor go to the track marks and triggers tab and then the advanced options at the bottom. Using the trigger radius tool, you can then set the radius to something smaller. I did this in a yard because having the 20 meter radius around a yard switch makes the moves quite unrealistic.
John
You sure can change the 20m limit, but as you said you can't remove the padlock.. In Surveyor go to the track marks and triggers tab and then the advanced options at the bottom. Using the trigger radius tool, you can then set the radius to something smaller. I did this in a yard because having the 20 meter radius around a yard switch makes the moves quite unrealistic.
John
ZecMurphy
Community Assistant
Good Morning George
You can adjust the 'trigger radius' of the lever using the trigger radius tools (found in the 'advanced' menu of the triggers section of the track tab). You can set this as small, or as large, as you like. Note, the junction will still lock if a vehicle is moving towards it at a rate that prevents it from stopping before the turnout.
Regards
You can adjust the 'trigger radius' of the lever using the trigger radius tools (found in the 'advanced' menu of the triggers section of the track tab). You can set this as small, or as large, as you like. Note, the junction will still lock if a vehicle is moving towards it at a rate that prevents it from stopping before the turnout.
Regards