Industry Loading Problem

[boxcar-willie]

TS12 SP1 - I have been creating modeltrainz routes, and having fun doing it, but I have run into a problem that has me stumped. I have a corn loading industry based on Grain_Complex_Corn_Mod1 <kuid2:439337:101172:1> by msgsapper, and a train of 4bay Cflow corn hoppers by majekar. In one of my routes, the AI train routed to the industry to load runs through just fine - the cars all show loaded after they leave the loader. In another route, they do not load at all unless I manually stop the train and back it through the loader after it leaves. Both routes are set up the same as far as production rates, etc. The loading animation looks the same. The AI trains in both routes are set up almost the same - nav via trackmark, nav to industry, load, and nav to trackmark. There are no faults listed in any of the assets nor any other errors I can find, yet it loads in one route and not the other. I welcome any suggestions!

Willie

 

[stagecoach]

Have you checked the initial amount of grain it holds. If it is empty then the train cant load.

 

[boxcar-willie]

I've checked that a bunch of times, as well as rate of production. I tried some things yesterday, and found out that the train loads fine if I drive it manually, but not if it's running AI under a programmed route. Like I said above - it works fine on an earlier route. I also discovered that a MIN track won't produce corn no matter how I set it up, but that also works fine in another route. I'd be pulling my hair out if I had any left.

Willie

 

[llebrez]

When nonsense sets, use the draconian solution: Erase the offending MIN and set it all again. Believe us, it is not the first time it happens. Is a pain, I know, but again is nonsense...