I'm running TRS2006 using ProtoLars INDs. After installing them in session,setting them up to load/unload tick the green check mark i then save and continue to the next one,after about 3 i do a test drive to see if they load what they are suppose to and they do.
I can run this 3 or 4 times save the session or not,every thing works fine but maybe the next time the INDs will show not con-fig.
Can anyone tell me why i lose the con-fig on my INDs and have to redo them all over again.(not one or two all 90)
Thank Danny5
I can run this 3 or 4 times save the session or not,every thing works fine but maybe the next time the INDs will show not con-fig.
Can anyone tell me why i lose the con-fig on my INDs and have to redo them all over again.(not one or two all 90)
Thank Danny5
