Hi all...
I've been having an issue with a defect detector in Trainz 2010... The exact name of the detector in-game is "Dragging Defects Detector Scripted With AEI Integration," though I'm not sure what the KUID number is. I have tested this detector in a few locations on a blank baseboard, with just enough track to run a small train through. I found some the detector locations work 100% of the time, as intended. Others hardly function at all, completely omitting the audio recording, or skipping certain parts. I have them all set to CSX, milepost..., track 0, yes to report number of axles, yes to train length, speed, and pre-train report, no to repeat train departure message, and hotbox frequency is off. Again, at most of these detectors, my train will pass over them and no report comes from the detector. Any ideas as far as what the issue might be?
Thanks for reading.
I've been having an issue with a defect detector in Trainz 2010... The exact name of the detector in-game is "Dragging Defects Detector Scripted With AEI Integration," though I'm not sure what the KUID number is. I have tested this detector in a few locations on a blank baseboard, with just enough track to run a small train through. I found some the detector locations work 100% of the time, as intended. Others hardly function at all, completely omitting the audio recording, or skipping certain parts. I have them all set to CSX, milepost..., track 0, yes to report number of axles, yes to train length, speed, and pre-train report, no to repeat train departure message, and hotbox frequency is off. Again, at most of these detectors, my train will pass over them and no report comes from the detector. Any ideas as far as what the issue might be?
Thanks for reading.