Help needed (TS12)

[macwilly]

I have two questions concerning TS12

Q1 How do I change the default junction lever or motor in TS12? It was easy in TS09.

Q2 Does anyone know if it is possible to have a free roaming interior camera in TS12? In earlier versions it was just a case of typing -FreeIntCam - in trainz options. This does not seem to work in TS12

I'd be grateful for any help

macwilly

 

[Euphod]

I tore through everything I could think of and could not find it.

 

[danny5]

Q1 to change the switch levers under track object choose the switch you want to use,click the delete button delete the switch you don't want then add the one you want.
Q2 you have to set your trainzoption to run as admin.then put in your changes.

 

[Euphod]

Danny, I know how to change a switch, I believe the OP is asking how to change the default switch than Surveyor will automatically install when building a route.

 

[macwilly]

Hi Guys

Thanks for your responses.

Danny, like Euphod, I to know how to change a point/switch lever in Surveyor, and again, as Euphod pointed out, it is the default I want to change. Your other suggestion on trainz options I shall attempt to fulfil.

Once again

Thanks

Macwilly

 

[Lewiscc65]

I have two questions concerning TS12

Q1 How do I change the default junction lever or motor in TS12? It was easy in TS09.

macwilly

You need to edit the config file of the county your using. You will see an entry, Defaultjunction. Just change the kuid to the one you want.

 

[Euphod]

Thanks Lewis, that helps!

 

[macwilly]

Lewis, that worked fine, thank you :wave:

Danny, I attempted your suggestion on Trainz Options, but I,m not sure about how to run it as the Administrator. Any suggestions would be appreciated.

Macwilly