Gantry signals

[leader2302]

The "NYO & W Home Gantry" signal I need to use is set too low for the proto-typical gantry I am using.

I looked in the config file for the height setting but I could not find anything that looks like the height setting.

Is their anyway to raise the height of gantry signals?

 

[rweber95]

Here is my experience. The base of all trackside objects set at the same level as the track. Using the height tool to move the track up and down causes a nearby trackside objects to move up and down with the track. The height of a gantry object is designed into the mesh and is not adjustable in Surveyor.

Bob

 

[lewisner]

The only way to raise the height of Trackside Objects is to attach them to Invisible Track and raise the IT so that they sit at the right height.They are then Dummies and you replace thir track function by Invisible Signals on the real track.Alternatively try using "JJS Cantilever Tower" or Gantry or LMS , LMSR or GWR Gantry from the DLS.

 

[lewisner]

P.S. I just had a look at them and they are reskins of Jonny211's GWR Signals so they will fit on top of this gantry KUID: 46219:37102.

 

[leader2302]

Lewisner,

Thanks for the invisible track idea. I will try that out.