Engineer to Conductor

[Rafter]

Hi everyone. I have been watching some videos on the internet, and saw that some people can move from the Engineers side to the Conductors side in cab mode. I wanted to know how I was supposed to do that. Any ideas. The answer could be right in front of my face and I am making myself look stupid for asking this, but I honestly have no idesa. Anything helps.

 

[Engineerkenny]

just hit [ to move to the next part of the cab and ] to move to the previous cab spot that you where in before and its okay I had never found this out until I had gotten trainz 12 then I started to explore the key buttons so I have 2009 2010 and 2012 and it took me two years to figure that out:hehe:

 

[Rafter]

thanks much for that. really helped me out.

 

[nicky9499]

In some cabs, the [ ] positions are sometimes not set, or maybe you feel the seat is a little too high/low/far back etc. Not a problem. Add -freeintcam to your trainzoptions.txt file and you now have power seats! Press arrow keys and PgUp PgDn.

 

[Bluewater]

Where would I put the -freeintcam in the .txt file?

 

[kenneth18278]

Where would I put the -freeintcam in the .txt file?

Just insert "-freeintcam" directly underneath the last entry in the list, don't forget the "-", save and close.

It works, I've just tried it myself. Arrow keys for the horizontal plane, and PageUp, PageDown for the vertical. The "[" and "]" keys still work for positioning where set up in the interior view, and the other keys for fine tuning.

Regards,

Ken

 

[jlp1551]

Is there someplace where these "commands" are listed so we can all have a look at them?

 

[clam1952]

In the Wiki http://en.wikibooks.org/wiki/Trainz/Trainzoptions.txt. Not forgetting some no longer work in newer versions of Trainz