Dash2 Cab Error

[B99]

Hi guys. I've been getting this error with JR's high hood SD45's. I believe it's an error with the Dash2 cab file. I've tried re-downloading an re-installing all the dependencies from the JR dependencies section, and still get this same error. When I go into the cab mode, it only shows the gauges and the throttle, reverser, and brake handles. Everything else is gone

Here's a screenie of that error. And yes, it's the same for each locomotive.

-B99

 

[rweber95]

When you get the exception error message you should click the More button at the bottom to get additional info about the error. Try that and post back here.

Bob Weber

 

[B99]

When you get the exception error message you should click the More button at the bottom to get additional info about the error. Try that and post back here.

Bob Weber

Roger that:

-B99

 

[norfolksouthern37]

what is happening is just as it says, it cannot find the shell entry in the config of the locomotive. it should be

shell     <kuid2:45324:91132:1>

in the kuid-table.


edit: after thinking about this some, i came back and read exactly what you said. all of the high hood SD45s have this problem?

 

[B99]

after thinking about this some, i came back and read exactly what you said. all of the high hood SD45s have this problem?

Yes sir, all the SD45 High Hoods I have, have this problem.

 

[norfolksouthern37]

thats like what 2?

i think this might be due to a file change i did since there are no high hood generic cabs. if you can send this to support we can get this fixed.

 

[B99]

Alright, sounds good, and yea, I think it is about 2, the MRL and SOU.