Consists Disapearing in TANE

Robert3a0

Active member
I wonder if anyone else has encountered this problem? I did a test run on one of the routes I am building for the TANE community, created a session, etc and loaded one of the consists from the TANE library, ran the test run, all OK and exited the session. When I re-opened the route in surveyor the previously loaded consist was no longer visible. However, it is still there, just totally invisible. When I run another train, it runs down the line to the point where the previous consist was and then it just disappears just like it was entering a Portal. I have tried everything I can think of, including hitting the consist delete button, removing the track (it won't let me make modifications because it thinks a train is still there). Does anyone have any ideas?
Regards
Bob
 
I had the same thing happen. The solution is a pain, but it works.

http://forums.auran.com/trainz/showthread.php?122222-Track-Cannot-be-Deleted&p=1432302#post1432302

Create a new layer and transfer the problem section to that layer. Delete the new layer and relay the track that was removed.

Regards,

 
Last edited:
Back
Top