Coach turned office

rick1958

Active member
Old-Coach.jpg


Anyone know where there may be something like this lying around? I know about the old tired caboose that's been around for ages. I was hoping to find something a little less dated
 
The late Ben Dorsey made a bunch of these.

<kuid2:210518:8503:1> Static Railcar 17
<kuid2:210518:8487:2> Static_Railcar_1
<kuid2:210518:8509:1> Static Railcar 23
<kuid2:210518:8508:1> Static Railcar 22
<kuid2:210518:8507:1> Static Railcar 21
<kuid2:210518:8506:1> Static Railcar 20
<kuid2:210518:8505:1> Static Railcar 19
<kuid2:210518:8504:1> Static Railcar 18
<kuid2:210518:8502:1> Static Railcar 16
<kuid2:210518:8501:1> Static Railcar 15
<kuid2:210518:8500:1> Static Railcar 14
<kuid2:210518:8499:1> Static Railcar 13
<kuid2:210518:8498:1> Static Railcar 12
<kuid2:210518:8497:1> Static Railcar 11
<kuid2:210518:8496:1> Static Railcar 10
<kuid2:210518:8495:1> Static Railcar 9
<kuid2:210518:8494:1> Static Railcar 8
<kuid2:210518:8493:1> Static Railcar 7
<kuid2:210518:8492:1> Static Railcar 6
<kuid2:210518:8491:1> Static Railcar 5
<kuid2:210518:8490:1> Static Railcar 4
<kuid2:210518:8489:1> Static Railcar 3
<kuid2:210518:8488:1> Static Railcar 2
 
@rick1958 I also have a set of wood deck splines, wood timber supports, and the stairs.

For making wood decks, ramps, platforms etc.

<kuid2:521966:21388:1> RC Plank Walkway - V1 - 1.49m wide
<kuid2:521966:21387:1> RC Plank Walkway - 1.45m wide
<kuid:521966:101376> RC Wood Plank Gangway
<kuid2:521966:21368:1> RC Plank walkway 9 meter wide
<kuid2:521966:21223:1> RC Plank walkway-wide spline

The 1.45 wide can be used to make walkways with varying board widths.
I.e > Place a spline length of 10 meters. Then place new spline points at the center of the length, then again on side of the center point.
You'll notice that the boards decrease in width each time you split a length by adding a new spline point. This allows you to use one asset for different decks.
Dragging the points left/righ allows for making decks/walkways with a rougher, made with found boards look.


For underdeck, and for making open sheds.

<kuid:521966:103772> RC Braced Timber Roof Support
<kuid:521966:103506> RC Timber Deck Support Shorter

Stairs >

<kuid2:521966:21492:1> RC Wood Stairs V2 - 2x size, 12 steps
<kuid2:521966:21251:1> RC Wood Stairs - Short
<kuid:521966:103595> RC Stairs 4ft v3 for Company House DES
<kuid:521966:103594> RC Stairs 4ft V2 for Company House DES
<kuid:521966:102485> RC Stairs 4ft for Company House DES
 
Last edited:
@rick1958 I also have a set of wood deck splines, wood timber supports, and the stairs.

For making wood decks, ramps, platforms etc.

<kuid2:521966:21388:1> RC Plank Walkway - V1 - 1.49m wide
<kuid2:521966:21387:1> RC Plank Walkway - 1.45m wide
<kuid:521966:101376> RC Wood Plank Gangway
<kuid2:521966:21368:1> RC Plank walkway 9 meter wide
<kuid2:521966:21223:1> RC Plank walkway-wide spline

The 1.45 wide can be used to make walkways with varying board widths.
I.e > Place a spline length of 10 meters. The place ne spline points at the center of the length, then again on side of the center point.
You'll notice that the boards decrease in width each time you split a length by adding a new spline point. This allows you to use one asset for different decks.
Dragging the points left/righ allows for making decks/walkways with rougher, made with found boards look.


For underdeck, and for making open sheds.

<kuid:521966:103772> RC Braced Timber Roof Support
<kuid:521966:103506> RC Timber Deck Support Shorter

Stairs >

<kuid2:521966:21492:1> RC Wood Stairs V2 - 2x size, 12 steps
<kuid2:521966:21251:1> RC Wood Stairs - Short
<kuid:521966:103595> RC Stairs 4ft v3 for Company House DES
<kuid:521966:103594> RC Stairs 4ft V2 for Company House DES
<kuid:521966:102485> RC Stairs 4ft for Company House DES
Sounds like you have me pretty much covered. Guess I better get to it... Thanks a lot for the help and info
 
Back
Top