Bridge problems

[Lo_Poly]

I've ran into a minor problem here. Where the section of bridge is missing, of course.

I can't stretch Kenichiro's bridge anymore, or else the pillar in the center becomes two pillars, effectively screwing everything up. Even if I create another segment, it splits up into two.

What do you suggest I do?

 

[Ferrous]

You mean that you can't have two pillars because it blocks stuff? Working off that premise, I'd suggest maddy25's YARN Bridge02 L2 DL2 -Si +Sh (KUID2: 124017:26037:2) and matching YARN Bridge02 Support (KUID2: 124017:26043:1) from the DLS. The supports are placed separately from the bridge, which should alleviate your problem. :wave:

 

[Lo_Poly]

You mean that you can't have two pillars because it blocks stuff? Working off that premise, I'd suggest maddy25's YARN Bridge02 L2 DL2 -Si +Sh (KUID2: 124017:26037:2) and matching YARN Bridge02 Support (KUID2: 124017:26043:1) from the DLS. The supports are placed separately from the bridge, which should alleviate your problem. :wave:

I forgot to mention that I want to keep Kenichiro's bridge.

 

[4ndylloyd]

Hi Lo Poly, I have had this sort of problem before on my own routes and have solved it by stretching the bridge between the two points. As you point out this creates two pillars but I then split the bridge using the split spline tool and then you should be able to move the newly created middle spline point about to be able to 'push' the pillar sited on the trackbed back between the tracks as it is in your picture. The down side is that you will have two pillars but at least you would have some control as to where they sit.

Andy