Antshire3

[Ian_Darvill]

Anthony

I have downloaded your layout and the scenario that goes with it. Both look great, but I have a problem with a missing asset. You have used kuid2:7155:60001:4 (autopilot command) problem is only kuid2:71155:60001:3 is available on the DLS. Where did you get :4 from?
Also running on TRS2009 some of the working assets, signals, passenger enabled stations and goods enabled assets will not transfer to 2009 and work. Easy solution is to delete these from the installed assets list on the DLS and re install. All work Ok then.
Well done I look forward to running it when I have sorted out the minor problems above.

Regards
Ian

 

[ajho]

Thanks Ian,

kuid2:7155:60001:4 (autopilot command) is built in in TRS2006 but has not been included in TS2009. The DLS only goes up to kuid2:71155:60001:3. one of a number of reasons why Antshire 3 is not TS2009 compatible. You can always just tell Stenka to "Drive".

I am working on a TS2009 version, but given the problems with trees and stuck trains, it's going to be a while.

 

[Ian_Darvill]

Ant

Thanks for info I have just run Eric over his route, after a few hicups, and seem now to have no probs, so at present it will run on 2009 with a few mods. I shall keep going, gives this poor old chap something to do, and keeps the brain active.

Regards Ian

 

[froobie]

Hello,
I downloaded Antshire3 and its session, loaded them & their dependencies into 2006 sp1, corrected some trivial errors in the dependencies and off I went to Driver. But I found nothing there. Went to Surveryor and there is the layout, loaded it and searched for Vehicles and there were none (as expected). Went back to content manager and verified: nothing unknown, nothing fawlty and no missing dependencies in either the layout or the session. For some reason the Session isn't loading. :'(

Any Ideas?
I found the answer: an error in the session config.txt: <kuid:nnn:nnn:n> should have neen <kuid2:nnn:nnn:n>

cheers,
--michael.