Allow AI to pass signal at danger command?

[Davie_UCF]

Just wondering if theres a command that allows an AI train to pass the next signal if at danger?

I'm trying to get a train to couple to its coaches which are behind a lot of junctions.. so im using the path rule to get it near them, but it doesn't want to pass a red signal because the overlap of the next block is occupied..

Allowing it to pass the red would solve this unless there are any other tricks?

Thanks

 

[honeymonster1971]

Davie, To get a AI passed a red to couple I use the "Set DDC throttle to" & "Couple Ahead" commands, Just make sure the correct path is set first or the loco will disappear never to be seen again (I had this happen once)

hth

Andi

 

[Davie_UCF]

That sounds perfect! especially with the path rule!! thanks so much!

 

[Travlar]

Davie,

If what honeymonster1971 does not work for you, try the Couple to Vehicle or Couple at Trackmark commands.

I have found that I can use the Couple to Vehicle command even when I have several junctions to pass through without having to resort to using the path rule.

Travlar