AI Commands in "Driver Setup" do not show up in game.

[DaveL]

The title says it all....
How do I correct or get around this ??

Dave

TRS19 Plus Beta
100500

 

[pitkin]

Do you mean that you cannot select them in the pull-down for a driver?

 

[DaveL]

No, I mean the drive to and the drive via commands that are entered in the session edit box for Driver set-up.
Unless they show in driver, I have no way to save them to run the session again. (If I enter them in Driver, they disappear as they are completed!).

Dave

 

[pitkin]

There are so many versions out now, I cannot say this definitively. But commands that are configured as not needing a driver will not show up in Driver Setup. They usually can be entered onto a driver's schedule while in driver mode.

 

[DaveL]

1. In Surveyor, click on Edit Session.
2. Highlight "Driver setup"
3. Click Edit
4. Assign Driver a Loco
5. Now enter driver commands (Drive Via, Drive To, and so on).
6. Now click on the "check mark" in the lower right corner.
7. Now return to Driver.
8. I get the right driver and loco, but NO commands I just entered.

9. WAG......my fault?, I don't know!!

Dave

 

[pitkin]

If you are using the unified system, then I have no idea.