36inch 4foot 6inch 3 Axle Truck failed

knuckles_133vocaloid

Trainz Veteran since 2004
"Error: Progressive meshes are no longer supported by Trainz. Though these meshes may work in Trainz, it is recommended that you switch to a LOD mesh."

Hello everyone, I'm new to the forum, the problem that I have is that the car "36inch 4foot 6inch 3 Axle Truck" has an error message that says that is required to change LOD mesh and not as do not fix it, if anyone knows how, please write me.
 
Welcome to the forums and to Trainz.

For this particular error, your best solution maybe to run PEV's Tools PM2IM utility then create a mesh-table to reference the changed mesh-type, or much easier to use AssetX. The problem is both methods can be quite complex for a new user, and for one whose version we don't know.

I recommend that you register your program so we know which version you are dealing with as that will be helpful when directing you on how to go about repairing the asset errors such as this. Once your program is registered, the version will appear next to your name on the forums as can be seen on mine.

Regards,

John
 
Back
Top