Recent content by TRS17985

Hi all, I countered this problem by using the autodrive pas signal command to cover trackstretches with no junctions. It keeps speed and signal status in consideration but is not hindered by in front trains.

Thanks Trevor, I’ll give it a try. Maybe it leads to something better, like a screen, activated by a key combination, that gives a peak at the actual variable values. Dreaming can’t Hurt.

Hi all, Is there a way to show the value of a variable while in driver mode? I know the procedure of showing a variable in the HUD , using the SHOW VARIABLE rule, but I would like a way to check on the actual value of a variable whilst playing driver mode. For instance through a key...

I have to count them, but centainly more then 100. I allready tried to reduce the number by integrating some of them in the driver command while only used once.

Hi all, Interesting discusion. However, when using schedules (a lot of them) I encountered the problem that the ”copy from’ command gets greyed out. Reducing the number of schedules solves the issue. Is this a time out problem? Or is there a solution work around? Thanks

More signals do not bring a solution. They are allready green but the train waits or reroutes if possible. More trackmarks, thus smaller stretches, are a possibility, but I already have a lot of them and they overload the dropdown lists caused by timeframe excess.

Hi all, I notice for quiet a while, that if a second consist enters a trackstretch following a train with the same trackmark to drive to, the second consist stops, waits and resumes online after the frist consist passed the targetted trackmark. So the second consists does not see the trackmark...

Hi there, Are you the owner of the TH R ROUTE LIST?. If so please contact me, because there is a problem under the new version of trs22. All paths turn red!! Thanks a lot. FRANK Belgium @thibaut @Thibaud

Hi there, Are you the owner of the TH R ROUTE LIST?. If so please contact me, because there is a problem under the new version of trs22. Thanks a lot. FRANK Belgium @thibaut @Thibaud

Hallo all, I try to contact @Thibaud, but with no succes. Can anyone help. @fant_autentico, @martinvk, @GIRAUD, @pinorev, @flomarie, @papou, @Frisson78, @guyader1 Thanks, Merci Frank, Belgique

Thibaud, Since the latest TRS22 update, your th r routelist rule is unusable. All paths turn red in surveyor and result in errors in driver. Can you check please. Thanks Merci

I use an nvidea geforce 1070 with 8 gig memory in an 16 gig i7 machine. I set the values you mentionned and got a better result. Less stutter, more splines loaded, a longer view in the distance and less need to press the PAUSE key to force a screen update. Cheers

Hi there, I have had the same problem,but when trying your settings on Vsync low and fast on the video card, I experience a massive improvement. SO THANKS FOR THAT. Less stutter and quicker spline load times. Thanks for sharing further performance improving setting.

Hi Thibaud, I'm using frequently tour Route Controll rules and commands. But I am in doubt about this parameter 'PERMIT TYPE' Can you please help me out with some info or indicate a link to a more detailed description please. Thanks lot

Hi all, I use 7 separate drivers setups using the indented notation with a seperation of a wait of 1 second, in trs22PE without any problem for my aprox 120 drivers. Ordered list Driver setup Wait Driver setup Wait Driver setup Wait...