Recent content by chili46

I have a couple of routes setup with a crop duster. Works and looks fantastic. All you really need are the invisible tracks and, of course, some planes that can "drive" on them. Setup, in Sessions, the commands to taxi, take off, land, and taxi again. You'll also want invisible speed signs on...

Do the coaches have internal working lights. There's a train command to turn on/off the internal lights which I use on all my passenger consists even though most coaches don't have the lights. That would be a cool, albeit not critical, feature.

Pretty much exactly the way I've done it. Simple and easy.

I've had a few issues with the TRC content, but for the most part it works pretty good. One of the issues I have noticed, if I do any track work close to the asset (signal lights, crossing stopper, etc), they stop working. Replacing the asset and it starts working again. This doesn't happen...

The URL works for me on Firefox (everyone should use Firefox). Avoid anything possible that comes from MS. Disclaimer: I do not work for Firefox. I'm a retired IT Engineering Specialist.

NVM. Didn't pay attention to the subject.

Good info. I was not aware of the EITsetpath option. I'll check it out. EIT seems like a good way to manage blocks between destinations, but also seems to have a high learning curve and possibly not as stable as I'd like. I'm a retired engineer so mastering this is a challenge and a goal of...

Wrong, again. I do have it set to following.

Okay, got it working on the Atlantic Map. Sort of... It appears that you must show all blocks (the yellow tube) before saving for it to work correctly. If only one block of a multi-block setup is showing, then the one not showing won't work. Also, I've found that if a train triggers the block...

Well, the test track works just fine. So, I guess the route itself has something causing the problem. I have multiple turnouts and signals on the test track just like the route has. The only difference is the length of the block on the test track is significantly shorter than the route. More...

Yes, yes. I know that.

All the blocks have two lines into one and on the other end one line to two. Signals are placed before the single track and just before the split to two tracks. This works on 99% of the blocks, however, there is one section that it doesn't work on. Entering the block from the left track sets the...

I've decided to try my hand at these Enhanced Interlocking Towers (EIT) to setup blocks on single track routes. For the "most" part they are working, but occasionally a train will come to the beginning of a block and will not advance forward because a turnout of something is preventing the block...

I'm wondering if the signals are too close to the switches and/or the switches trigger radius is defaulted to 20 meters. Try setting the switch radius to .5 meter.

Version 4 is available on DLS for the three Whistle Signs. <kuid2:324956:100418:4> Invisible Whistle w/Horn Seq V4 <kuid:324956:100900> Whistle Sign W w/Horn Seq (L) V4 <kuid:324956:100897> Whistle Sign W w/Horn Seq V4 The invisible sign has been updated to V2 <kuid2:324956:100327:3>...