Hi and Happy New Year.
One major issue I seem to have when creating sessions is getting an uncouple command that works consistently.
I've tried loads of these, decouple loco, uncouplez, split consist (at 0) and at some time or another all of these will fail to work for some unknown reason. Does anyone share this experience and is it a known fault?
I note that there is a built in decouple command, which is ticked in the command list but never seems to show in the available commands when I try to set up a session. It's a fundamental command that really needs to work effectively every time- or maybe it's just faulty on my installation- what do others think about this and in the meantime can anyone recommend a sure fire 100% cosistent uncouple command they have used extensively in TS12?
Thanks for any advice.
One major issue I seem to have when creating sessions is getting an uncouple command that works consistently.
I've tried loads of these, decouple loco, uncouplez, split consist (at 0) and at some time or another all of these will fail to work for some unknown reason. Does anyone share this experience and is it a known fault?
I note that there is a built in decouple command, which is ticked in the command list but never seems to show in the available commands when I try to set up a session. It's a fundamental command that really needs to work effectively every time- or maybe it's just faulty on my installation- what do others think about this and in the meantime can anyone recommend a sure fire 100% cosistent uncouple command they have used extensively in TS12?
Thanks for any advice.