Speed Limits

[therabbit]

Is there anyone who can direct me to how speed limits work in surveyor.

I set speed limits but trains run at half the posted speed or the speed limit setting has no effect what ever

[trackplate]

Check the signals, it sounds as though you are some short, hover the mouse pointer over each one in the problem area or place a piece of rolling stock in-front of each one to check its function you can always drag the rolling stock along to the next one when you are checking like this
Trust this helps a little
Regards Bob V

[Mr_D]

Half speed means you are running under a caution signal so you may need to make more blocks. Also the signal may be yellow because of a junction direction rather than another train. If a junction is set against the train (you have told it to go right and the junction is set left) you are speaking of it will cause a yellow signal until it enters that block and then red until the junction is set the direction the route is telling it to go.