Once again, and for the final time, I shall ask…

[Brickticks]

On TS2 Ipad, how in the name of steam does one change the interior viewpoint when viewing a car or locomotive with multiple interior viewpoints from cab view? Again, I will state that my Ipad is simply too old, by just one generation, to run TS3 Ipad. So, for the sake of my sanity, and the enjoyment of others who find themselves unable to run TS3 Ipad due to outdated equipment, I shall repeat the question, how in the name of coal fired steam does one switch between the different interior viewpoints of locomotives and rolling stock that support cab view with multiple interior viewpoints? A quick response would be much appreciated, thank you. Rockatoa, Brickticks out!

 

[Brickticks]

Does anybody actually care? No? Well, back to No Man’s Sky then, until I can figure this out!

 

[pware]

Does anybody actually care? No? Well, back to No Man’s Sky then, until I can figure this out!

It is possible that few people are actually using TS2 on an iPad.

 

[1611mac]

Question would be better placed in the iPad forum and not the General Trainz forum.

 

[Brickticks]

I tried putting it there, among other questions, and never got a response about this particular question.

 

[mtldrm38]

Did you look it up in the trainz wiki? should be directions and how to's....

 

[Brickticks]

Did you look it up in the trainz wiki? should be directions and how to's....

Tried that, couldn’t find anything there.

 

[amigacooke]

Perhaps it's not possible? I can't check as I deleted 2 when 3 came out.